Shalimar Zero Damp Interior is a specially formulated, elastomeric emulsion based undercoat designed to combat interior surface dampness. As an economical yet highly effective anti-damp solution, it acts as a protective barrier, preventing moisture from seeping through and affecting the top coat. This primer not only enhances the durability but increases 20% coverage of topcoat along with a 4-year anti-dampness warranty, ensuring long-lasting protection.
SILICONE BASED ELASTOMERIC EMULSION
100% ELONGATION RESISTS CRACKS
20% HIGHER TOPCOAT COVERAGE
SUPERIOR WHITENESS & HIDING
PASSES 4 BAR NEGATIVE WATER TEST
4-YEAR WARRANTY
Before putty application it important to ensure that the substrate shall have no chalking, loose sand or paint particles and free from oil and grease stains. For fresh plaster, the substrate shall be completely cured, crack free and in sound condition.
Waterproof Putty and ZeroDamp interior system has been used for interior vertical walls and that the entire affected wall is to be covered.
Any active source of leakage needs to be treated before the application of Waterproof Putty and ZeroDamp Interior.
New masonry surfaces must be allowed to cure completely for best results. It is recommended to allow 28 days as curing time for new masonry surfaces.
Ensure that surface is completely free from all dirt, loosely held plaster, powdery residue, oil, grease, or any other contamination. Any previous growth of fungus, algae or moss needs to be removed thoroughly by vigorous wire brushing and cleaning with water ,For filling cracks up to 3mm use Crack Seal.
Clean the surface to ensure it is free of any dirt and lose particles. Sand the surface with sandpaper 180 or use wire brush for vigorous cleaning of substrate if required and wipe it clean. Apply Shalimar Paints Wall Primer (Water Thinnable) with 100% dilution. Let it dry for 3-4 hrs. · Apply 2 coats of Shalimar waterproofing wall putty. Allow it to dry for 4- 6 hrs. Sand with sand paper 180. Wipe and clean the surface with dry muslin cloth. · Stir the contents and apply undiluted one coat of Zero Damp Interior with Shalimar Paints Brush / Interior Sponge Roller with a forced coverage of 9 – 10 sq.m./L (1 sq.m.=10.76 sq.ft.). Allow to dry for 3-4 Hrs. · Coverage may vary on surface porosity and differential drying of the existing putty surface. · Post drying of Zero Damp Interior, apply topcoats as per recommendation
Clean the surface to ensure it is free of any dirt, black spots and lose particles. Sand the surface with sandpaper 180 or use wire brush for vigorous cleaning of substrate if required and wipe it clean. · Stir the contents and apply undiluted one coat of Zero Damp Interior with Shalimar Paints Interior Brush/ Interior Sponge Roller with a forced coverage of 9-10 sq.m./L(1 sq.m.=10.76 sq.ft.). Allow to dry for 3-4hr.